|
|
|
Z Series - Nose Over/Under Conveyor
Frame
 Base frame made
from 4-1/2"H x 1-1/8"W anodized extruded
aluminum frame- Open channel frame
design with easy T-nut mounting along entire frame
- 2-1/2"H 90° extruded
aluminum side rails on horizontal with 3/8" belt
overlap per side
- Incline frame
section made from extruded aluminum profile that includes the 2-1/2"H
90° side rail
- Stainless steel
belt pan with reinforcements
Drive
- Power transmission
via chain of a 110 VAC 60 Hz single phase gearmotor TEFC motor and
reducer with fixed belt speed 15 fpm
- Thermal overload
protected motor starter (on/off) with grounded 15ft.
SJ cord and standard plug
- Protected motor
location inside the base frame underneath incline section. Motor
locations may vary depending
on conveyor size
- 2-3/8" dia.
extruded aluminum drive & idle
pulleys
- Pushing belt design
for smooth transition between horizontal & incline
section
- Pulleys are equipped
with lifetime lubricated maintenance free double sealed ball bearings
Belt
- Smooth surface,
endless polyurethane belt (green); temperature resistant up to 212°F,
permanent anti–static with 3/4" high
cleats
- V-guide self aligning
belt tracking system
- Spring loaded
automatic belt tensioner at end of incline section to automatically
compensate for varying belt tension
when the angle
of
the incline section is changed
Legs
- Perforated zinc
plated steel legs with 2-3/8" dia. swivel
castors, (2) locking & (2) non-locking. Adjustable leveling are
available
- Sliding sleeve
height adjustment with screw knob fastener & positioning
pin (no tools required)
- Leg height determined by application
|
|
