|
|
|
LSE Series - Horizontal Conveyors
Frame
 3"H
x 1-1/4"W anodized extruded aluminum profile with 1 3/8" sq.,
18" centered aluminum frame cross supports- Open
channel frame design with easy T-nut mounting along entire frame
- 3-1/2 "H
90° extruded aluminum side rails with PVC skirting that
overlaps belt 3/4" per side to keep small parts away from pinch
point between side rail and belt
- Galvanized
steel belt pan
Drive
- Power
transmission via chain of a 110 VAC 60 Hz single phase TEFC motor and
reducer with fixed belt speed 20 fpm
- Thermal
overload protected motor starter (on/off) with grounded 15ft. SJ cord
and standard plug
- Protected
motor location underneath conveyor at discharge end
- 2-3/8 " dia.
extruded aluminum drive & idle pulleys
- Pulleys
are totally enclosed with safety guards, removable for maintenance and
equipped with lifetime lubricated maintenance free double sealed ball
bearings
- Belt non-slip surface, endless PVC belt (green); temperature resistant up
to 160°F, permanent anti-static.V-guide self-aligning belt tracking
system.Belt running direction towards motor
Legs
- LSE/1A
& LSE/1 are equipped with a single perforated zinc plated steel
leg, mounted to a low profile solid steel platform (Only 1" H
- slides easily underneath frame of injection molding machine)
- 59" & 78" long
models are equipped with dual 39"H perforated
zinc plated steel legs mounted to a welded rectangular steel base
and
have (2) non-locking 2-3/8," dia. swivel castors and (2) tubular
posts. Total platform height is 4-1/2"
- Sliding
sleeve height adjustment with screw knob fastener & positioning pin (no tools required)
- Standard
range of height adjustment 13" to 37" (floor to belt)
- Easy
0-45° angle adjustment using ratcheting handles to lock the
conveyor in the desired position without the use of tools
- Alternate
leg heights
available
|
|
