When a diverter is use to remove bad parts, a signal from the molding machine activates a time sequence that is used to control the diverter.

This pneumatic chute diverter is fitted onto the end of a conveyor. While this particular unit was developed to remove bad parts, it could also be used to periodically remove parts for inspection or as a two station box-filling system.

How does it work?

• There are two chutes at the end of the conveyor, an upper chute and a lower chute. Pneumatic cylinders are used to raise or lower the upper chute.
• If the shot is good, the upper chute remains down and the good parts exit through it into a container.
• If the shot is bad, the molding machine sends a signal to the diverter to raise the upper chute. This creates an opening which allows the bad parts to fall into the lower chute, and into another container.
• After a predetermined period of time, the top chute returns to its original position.