| |
|
|
|
 LH
Series - Heavy Duty Conveyors Return
to LH Series conveyors
Frame
- 6"H x 1-3/4"W
heavy-duty anodized extruded aluminum profile with 1-3/8" sq.,
18" centered aluminum dual frame cross supports.
- Open channel
frame design with easy T-nut mounting along entire frame.
- Heavy-duty
4"H 90° extruded aluminum side rails with reinforcement;
3/8" belt overlap per side.
- Galvanized steel
belt pan.
Drive
- Power transmission
via chain of a 110 VAC 60 Hz single phase TEFC motor and reducer
with fixed belt speed 20 fpm.
- Thermal overload
protected motor starter (on/off) with grounded 15ft.
SJ cord and standard plug.
- Protected motor
location underneath conveyor at discharge end.
- 4" dia. extruded
aluminum drive & idle pulleys.
- Pulleys are totally
enclosed with safety guards, removable for maintenance and equipped
with lifetime
lubricated maintenance free ball bearings.
Belt
- Smooth surface,
endless polyurethane belt (green); temperature resistant up to 212°F,
permanent anti-static.
- V-guide self-aligning
belt tracking system.
- Belt running direction
towards motor. It can be rewired to be reversed.
Legs
- Heavy-duty perforated
zinc plated steel legs with leveling pads. Plate with mounted nylon
swivel
castors, locking & non-locking
are available.
- Sliding sleeve
height adjustment with screw knob fastener & positioning
pin (no tools required).
- Leg height determined
by application.
Return
to LH Series conveyors
|
