| |
|
|
|
LI Series - Incline
Conveyors Return to
LI Series conveyors
Frame
- 3"H x 1-1/4"W
anodized extruded aluminum profile with 1-3/8" sq., 18" centered
aluminum frame cross supports.
- Open channel frame design with easy T-nut mounting along entire frame.
- 2-1/2"H
90°extruded aluminum side rails with 3/8" belt
overlap per side.
- Galvanized steel
belt pan.
Drive
- Power transmission
via chain of a 110 VAC 60Hz single phase TEFC motor and reducer with
fixed belt speed 20 fpm.
- Thermal overload
protected motor starter (on/off) with grounded 15ft.
SJ cord and standard plug.
- Protected motor
location underneath conveyor at infeed end.
- Extruded aluminum
drive & idle
pulleys.
- Pulleys are totally
enclosed with safety guards, removable for maintenance and equipped
with lifetime lubricated maintenance
free double sealed
ball bearings.
Belt
- Non-slip surface,
endless PVC belt (green); temperature resistant up to 160°F,
permanent anti-static.
- V-guide self aligning
belt tracking system.
- Belt running direction
away from motor. It can be rewired to be reversed.
Legs
- Perforated zinc
plated steel legs with double T-base & leveling
pads. Castors (shown) are available.
- Sliding sleeve
height adjustment with screw knob fastener & positioning
pin (no tools required).
- Easy 0-45° angle
adjustment using ratcheting handles to lock the conveyor in the desired
position without the
use of tools.
- Leg height determined
by application..
Return
to LI Series conveyors
|
