| |
|
|
|
 LT
Series - Horizontal to Incline Conveyors
Return to LT Series Conveyors
Frame
- Base frame made
from 4-1/2"H
x 1-1/8"W
anodized extruded aluminum frame.
- Open channel frame
design with easy T-nut mounting along entire frame.
- 2-1/2"H 90° extruded
aluminum side rails on horizontal with 3/8" belt overlap per
side.
- Incline frame
section made from extruded aluminum profile that includes the 2-1/2"H
90° side rail.
- Stainless steel
belt pan with reinforcements.
Drive
- Power transmission
via chain of a 110 VAC 60 Hz single phase TEFC motor and reducer
with fixed belt speed 20 fpm.
- Thermal overload
protected motor starter (on/off) with grounded 15ft. SJ cord and
standard plug.
- Protected motor
location underneath conveyor at infeed end.
- 4" dia. extruded
aluminum drive & idle pulleys.
- Pulleys are totally
enclosed with safety guards, removable for maintenance and equipped
with
lifetime lubricated maintenance
free sealed ball
bearings.
Belt
- Smooth surface,
endless polyurethane belt (green); temperature resistant up to 212°F,
permanent anti–static
with 3/4" high
T-cleats.
- V-guide self aligning
belt tracking system.
- Spring loaded
automatic belt tensioner at end of incline section to automatically
compensate for varying belt tension
when the angle
of
the incline section is changed.
Legs
- Perforated zinc
plated steel legs with 2-3/8" dia. swivel castors,
(2) locking & (2) non-locking.
- Sliding sleeve
height adjustment with screw knob fastener & positioning
pin (no tools required).
- Leg height determined
by application.
Return
to LT Series conveyors
|
